Haulin' Ass on Laughin' Gas !

[Recklessrob]

:evil; I started installing the nitrous kit in the Mazda
P/U Saturday afternoon. I still have to figure out where to
put the activating switch and run the N2O feed line. I
also got some bottle issues to take care of. I'll try to get some pics
up later in the week. :supz:

[87natty]

Rock it! Or should I say, rocket?

[SuperSix]

:evil; I started installing the nitrous kit in the Mazda
P/U Saturday afternoon. I still have to figure out where to
put the activating switch and run the N2O feed line. I
also got some bottle issues to take care of. I'll try to get some pics
up later in the week. :supz:

Why?!?!?

[Recklessrob]

Why not ?
It'll be a riot to race. 3.8 liter Buick V6
on N2O !  :supz:

[SuperSix]

Why not ?
It'll be a riot to race. 3.8 liter Buick V6
on N2O !

[Recklessrob]

I see you haven't looked at my signature or my gallery photos.
Mazda never made a B3800 !

[87natty]

Oh Jesus, they did make those damn 2300's with the 4 cylinders with 8 plugs though! Ever take the back 4 plugs out? I get the shakes thinking about it...

[Recklessrob]

Well as promised and/or threatened, here are the pics.... :evil;

[Recklessrob]

1 more.....

[87natty]

Is that an AFB with a plate setup? That's my NA dream setup man! What cam are you using? Heads? Tranny? What manifold too?

[Recklessrob]

Cam: Elgin 224 dur @ .050" .496" lift int & exh
Intake: Kenne-Bell Number 1 single plane
Heads; PORTED 445's with stock size stainless valves
Block: 6190 .030" over 9.1:1 cr
Trans: THM 350 with B&M shift kit HD V8 internals and 10" TCI non-lockup converter
Carb Modified 500 cfm Carter AFB

[Be4u]

RecklassRob, where are you? Did Dceptcn do something to you when Y'all met? lOl

[DCEPTCN]

RecklassRob, where are you? Did Dceptcn do something to you when Y'all met? lOl

Such as?

[Be4u]

Such as....toss him in your trunk?

[Recklessrob]

Nah, I've been wicked busy. I'm still dialing in the NOS kit. It
seems to lean out at high RPM. I think my fuel pump isn't
keeping up. Other than that, it kicks ass!  I looked at a '96
S-10 to replace the Mazda with. Problem is, with a '96, it has
to pass an OBD II emmisions test. So its not a very good candidate
for my old GN engine. The Mazda is starting to rust out bad.
I've allready welded up a few holes in the frame. So I'm just trying
to make it as fast as I can, before I retire it. :evil;