Took the Vega for a shake down run hour and a half each way. Car meet in Nanaimo 130 cars. The car was a hit old guys loved it’s vintage the kids thought drive train was cool.
So I wired my power logger to the green wire terminal A on C437 like I had it in the white car and nothing, the connector is not connected to anything and I have ran power to terminal F to run the motor, there is no power at the map sensor and I have probed the C437 connector terminal G black and white marked as ground has 5 volts? Nothing at terminal B I jumped the G and B together and got a reading of 20 PSI on the powerlogger? Is it as simple as grounding terminal G?
Well now it will turn to bad my drive shaft was 3” short. Going to have the Buick’s shortened to fit
Just to be certain install yoke all the way in till it bottoms on the output shaft, measure center to center on U joints subtract 1” for play that’s what I need?
so I tried to fire the engine today, ran into a no spark, the module is a TR6 and its getting power cycles on runs thru the lights, crank light stays on constant and cam phase light appears to work as it should lite up when I was setting the cam sensor and flashes when rolled over. I guess I have a bad ground or something in my harness. The power to both pink and black wires appear good. Have I mentiond how much I hate wiring before?
Show Posts
