Messages

46

General Auto Tech / nocooler's firechicken thread

« on: September 06 2018, 09:28:05 PM »

Hey where did the extra holes come from 😂


Sent from my iPhone using Tapatalk Pro

47

IHADAV8 Playground / Re: TR6 problems

« on: September 03 2018, 04:17:56 PM »

so I pulled some timing and added boost to lean it out, seems to be working great a couple hits from a dig and its ripping must have gotten some moisture in the computer or the chip somehow. I have relocated the computer and positioned it to avoid this in the future.

48

IHADAV8 Playground / Re: TR6 problems

« on: September 02 2018, 11:18:15 AM »

put an old chip in it 5.7 I think burned with 25 degrees of timing turned it down to 17 PSI on a preliminary test hit it seemed fine but  was very fat. I will tune it a bit and let you know how I make out.

49

IHADAV8 Playground / TR6 problems

« on: August 31 2018, 07:11:19 PM »

14 on the logs


Sent from my iPhone using Tapatalk Pro

50

IHADAV8 Playground / TR6 problems

« on: August 31 2018, 05:52:15 PM »

Ok so compression is with in 5lbs around 130  plugs all look good


Sent from my iPhone using Tapatalk Pro

51

IHADAV8 Playground / TR6 problems

« on: August 30 2018, 11:25:58 PM »

Bob has the TR6 I have borrowed a known good stock set up.


Sent from my iPhone using Tapatalk Pro

52

IHADAV8 Playground / TR6 problems

« on: August 30 2018, 09:58:48 PM »

Well it’s not the crank sensor.
I’m gonna pull all the plugs and check them and give it a compression test.
The valve train sounds fine the spring where new this winter Comp 941
It’s like it hits a rev limiter at 4000 rpm I stayed into it a bit just started to lose steam. Hitting on 4 out of 6 holes.


Sent from my iPhone using Tapatalk Pro

53

IHADAV8 Playground / Re: TR6 problems

« on: August 30 2018, 03:40:06 PM »

well its back... what ever my problem is its not my ground or module I have a stock known good in it now. I checked the fuel pressure it seems good rises with boost, the symptoms pointed to ignition if I launch it hard once I get to about 4000 rpm 19, 20 psi it falls flat. All the intercooler hoses are tight and it drives great under normal driving conditions no codes and my logs look fine no knock fueling is good. I'm gonna swap out the crank sensor see if its giving me grief and make sure the balancer is tight.
any other suggestions?

54

IHADAV8 Playground / Re: Another project

« on: August 29 2018, 02:27:08 PM »

Nice Work Jason !

55

IHADAV8 Playground / TR6 problems

« on: August 28 2018, 12:08:49 PM »

Delco coils Jason?
The ING require a different harness correct?


Sent from my iPhone using Tapatalk Pro

56

IHADAV8 Playground / Re: TR6 problems

« on: August 26 2018, 12:48:59 PM »

Well I took my car to a little test and tune with a borrowed module and coil, made a couple decent licks but when I left hard it fell on its face.
Today I went of the car and think I may have found the problem, i have a cable from the battery to the engine block, it was loose.....
this would explain a lot of my issues I think eating coils and a scorched module.

57

IHADAV8 Playground / TR6 problems

« on: August 23 2018, 06:42:17 PM »

Bob will look it over and has sent me a file to update the dwell to hopefully eliminate my issue
 


Sent from my iPhone using Tapatalk Pro

58

IHADAV8 Playground / TR6 problems

« on: August 21 2018, 10:01:08 PM »

Would misfire and fall on it’s face.


Sent from my iPhone using Tapatalk Pro

59

IHADAV8 Playground / TR6 problems

« on: August 21 2018, 04:41:11 PM »

Well I never had a nonstart but replaced 3 LS coils ...


Sent from my iPhone using Tapatalk Pro

60

IHADAV8 Playground / TR6 problems

« on: August 21 2018, 04:07:00 PM »

Well that could be the problem looked dry inside but who knows


Sent from my iPhone using Tapatalk Pro