« previous next »
Pages: 1 [2]   Go Down

Author Topic: 87 GN won't start. Scanmaster not giving any reading  (Read 6591 times)

0 Members and 4 Guests are viewing this topic.

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: 87 GN won't start. Scanmaster not giving any reading
« Reply #15 on: June 30 2020, 10:03:09 PM »
Good deal!
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: 87 GN won't start. Scanmaster not giving any reading
« Reply #16 on: July 01 2020, 04:49:57 PM »
Check the connectors on the ECM, pull them off carefully , any corrosion?
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline phagen28

  • Bone Stock
  • **
  • Posts: 20
  • PSI: 0
    • View Profile
Re: 87 GN won't start. Scanmaster not giving any reading
« Reply #17 on: July 11 2020, 11:17:48 AM »
Ok I got the pump, dropped the tank and put in the new pump. started right up and runs fine. thanks for your help! I always know where to look...here!
Logged

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: 87 GN won't start. Scanmaster not giving any reading
« Reply #18 on: July 11 2020, 12:32:10 PM »
Glad it's going. Now, what happened with the SM?
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline phagen28

  • Bone Stock
  • **
  • Posts: 20
  • PSI: 0
    • View Profile
Re: 87 GN won't start. Scanmaster not giving any reading
« Reply #19 on: July 11 2020, 09:09:26 PM »
I'm not sure Steve. When it started the SM worked as it always did.I did hard wire the SM directly to the back of it and a good ground. My intent is to run it some and then check it for any newly stored codes. I will be back after I do that. Thanks again!
Logged
Pages: 1 [2]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal