Stock-ish fuel pumps

[Steve Wood]

Works fine on one of my cars. And it works on Chris a Padillo's car as of last week.

[Forzfed]

Works fine on one of my cars. And it works on Chris a Padillo's car as of last week.

Steve, are you talking about a Walbro 450?  All these new pumps keep coming out.  I guess I will see how my AEM performs.

[Scoobum]

Works fine on one of my cars. And it works on Chris a Padillo's car as of last week.

Steve, are you talking about a Walbro 450?  All these new pumps keep coming out.  I guess I will see how my AEM performs.

Steve sent me this link awhile back. Might be the one he's using. For those that have asked, it's the link I've been sending them.

http://www.jayracing.com/index.php?main_page=product_info&cPath=2_5&products_id=3932

[Scoobum]

I'm assuming the 450's and larger are to handle the volume required for E85. My 6.7 at 105 was with a single 255 and 60's with race gas. Eric says 60's will take you to a mid 10 with race gas...and you're tapped out. He wasn't wrong.

[Steve Wood]

Dw300 it's what I'm talking about. Have one in my T. Chris was told the other day that it would not work with his hot wire kit and the special return line kit.... Worked fine without either

[reality]

Couldn't Daveismissing make something to reduce the voltage to the pump at low boost and ramp up the voltage at higher boost?

[Forzfed]

Dw300 it's what I'm talking about. Have one in my T. Chris was told the other day that it would not work with his hot wire kit and the special return line kit.... Worked fine without either

I've heard most people were able to run that pump without a bigger return.

[Scoobum]

Couldn't Daveismissing make something to reduce the voltage to the pump at low boost and ramp up the voltage at higher boost?

Or how about this:

https://www.youtube.com/watch?v=zydPp_m-hQg

[daveismissing]

Couldn't Daveismissing make something to reduce the voltage to the pump at low boost and ramp up the voltage at higher boost?

We could feed it with a lossy 22/24Ga teflon ( so we don't care if it get warm) wire and only switch on the hotwire circuit when required

[reality]

Couldn't Daveismissing make something to reduce the voltage to the pump at low boost and ramp up the voltage at higher boost?

Or how about this:

https://www.youtube.com/watch?v=zydPp_m-hQg

No the exact opposite. the 340lph pumps are not a problem at wot where you are using the fuel the problem is at idle. that volt booster should not be needed with enough pump at least for fuel.

[motorhead]

Couldn't Daveismissing make something to reduce the voltage to the pump at low boost and ramp up the voltage at higher boost?

We could feed it with a lossy 22/24Ga teflon ( so we don't care if it get warm) wire and only switch on the hotwire circuit when required

Kenne Bell has a Boost-A-Pump that does this (my guess is via some capacitors).

[daveismissing]

Ron and I are working on the choke-a-pump

[motorhead]

Ron and I are working on the choke-a-pump

I'll admit I LOL'd.

[reality]