« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: where the f&*k you been????  (Read 11005 times)

0 Members and 7 Guests are viewing this topic.

Offline blown1

  • Turbo Street Stock
  • ****
  • Posts: 215
  • PSI: 0
  • send em all back!
    • View Profile
Re: where the f&*k you been????
« Reply #30 on: May 28 2006, 06:59:50 PM »
heres the dyno sheet, shut it down as throttle stuck, torque NEVER  leveled out, was still climbing, as was HP.  made 579 hp, shoulda went over 600hp, TO THE REAR WHEELS !!!!
Logged

Offline Racer X

  • Turbo Street Eliminator
  • ******
  • Posts: 1347
  • PSI: 0
    • View Profile
    • http://www.hotrodbuick.com
where the f&*k you been????
« Reply #31 on: May 28 2006, 07:11:46 PM »
Yeah, you should let me drive it.
Logged
2008 Charger SRT-8
2009 Challenger R/T
any questions?

Offline Ttype83

  • Turbo Street Modified
  • *****
  • Posts: 645
  • PSI: 0
    • View Profile
Re: where the f&*k you been????
« Reply #32 on: May 28 2006, 07:13:07 PM »
Sweet ride..take a change of shorts with you to the track..
Logged
Jim Seaton 83 T type
CarbedHotAir Slug
2 1/2\" mandrel bent dual exh wo/cat & Dynomax race bullet mufflers, MSD coil, MSD BTM,K&N filter, K hanger, CS secondaries, Comp cam 260H, BRF Trans, ET 14.8 @ 92mph 14 psi boost
Comp Cams will never get another dime of my money
USAF (retired w/22yrs)
86 T-type Stock IC & Turbo, Razor Alky, 50lb inj, Hotwire & fuel pump, tt chip

Offline Be4u

  • Turbo Street Outlaw
  • *******
  • Posts: 3548
  • PSI: 0
    • View Profile
    • http://www.cardomain.com/memberpage/400586
where the f&*k you been????
« Reply #33 on: May 28 2006, 07:54:56 PM »
RX, thats too much car for you. I'd have to teach you how to drive it. Forget Sylvans tires, I'm going to commandeer Cruzn's ride. Nice stuff man!
Logged
Save the bumper fillers!
Move to Canadia!

Offline blown1

  • Turbo Street Stock
  • ****
  • Posts: 215
  • PSI: 0
  • send em all back!
    • View Profile
Re: where the f&*k you been????
« Reply #34 on: May 28 2006, 08:01:50 PM »
Thanks
 but all I did was buy it,  Ray Bunch built it,  now I need to  tune it, and make some mods,  I have a 62mm TB, and hemco , well see what that does for it.
 car weighs 3040, and I have the weigh slip too,  
 ain't this sh!t fun !!
Logged

Offline Be4u

  • Turbo Street Outlaw
  • *******
  • Posts: 3548
  • PSI: 0
    • View Profile
    • http://www.cardomain.com/memberpage/400586
Re: where the f&*k you been????
« Reply #35 on: May 28 2006, 08:10:25 PM »
Cant no one say that your not young at heart. Your acting like a highschooler :supz:
Logged
Save the bumper fillers!
Move to Canadia!

Offline blown1

  • Turbo Street Stock
  • ****
  • Posts: 215
  • PSI: 0
  • send em all back!
    • View Profile
Re: where the f&*k you been????
« Reply #36 on: May 28 2006, 11:59:50 PM »
bodies old, mind is  young !
hey, I can finally afford to play hard, so.........I will!
I'd like to see  lo 10 sec time slip,  ( from my car ,you wise crackers)
I do some 1/8  mi set up, then when I'm sure it'll work , 1/4 mi....
I'm thinking no cage, as its such a sleeper,   :cool;
but that means only one or two runs before they  throw me out.


Thanks guys
Logged

Offline Recklessrob

  • Turbo Street Outlaw
  • *******
  • Posts: 5112
  • PSI: 3
    • View Profile
Re: where the f&*k you been????
« Reply #37 on: May 29 2006, 06:29:11 PM »
Quote from: "blown1 @ Sun May 28, 2006 7:01 pm"
Thanks
 but all I did was buy it,
Logged
Rob

Offline blown1

  • Turbo Street Stock
  • ****
  • Posts: 215
  • PSI: 0
  • send em all back!
    • View Profile
Re: where the f&*k you been????
« Reply #38 on: May 29 2006, 08:52:23 PM »
I already have a hemco, 65mm I think,  tell me more about precision..... ....
where do you get one,  some info,  etc,

I love this sh!t,   made a hard  run this am, out in the industrial area,
 won't hook , so don't try from a stop,  but eased into it from 40-45, held it so I could  watch boost, EGT, nock sensor,
 22lbs , 1200 degrees, and no knock, it was spinning when it went into 3rd,
 after I shut down, pulled over, stepped out,  and fingers  were shaking....
 IT FELT SO GOOD!!!!!
 Ray told me it likes 25-26 lbs, and I'll need more methanol,

 guess I'll mount up the M/T drag radials,
Logged

Offline 87natty

  • Turbo Street Outlaw
  • *******
  • Posts: 3616
  • PSI: 0
    • View Profile
    • http://www.wix.com/lynch455/science
where the f&*k you been????
« Reply #39 on: May 30 2006, 04:14:44 PM »
Ray's good shit, you need to get him over here.
Logged
My 1958 Mamiya can beat up whatever camera you just wasted your money on.

DCEPTCN

  • Guest
where the f&*k you been????
« Reply #40 on: May 30 2006, 04:42:34 PM »
Quote from: "87natty @ Tue May 30, 2006 1:14 pm"
Ray's good shit, you need to get him over here.
Yeah Ray's a good guy.
Logged

Offline 87natty

  • Turbo Street Outlaw
  • *******
  • Posts: 3616
  • PSI: 0
    • View Profile
    • http://www.wix.com/lynch455/science
where the f&*k you been????
« Reply #41 on: May 30 2006, 05:15:29 PM »
Ray's car gave me the piss shivers when I saw it.
Logged
My 1958 Mamiya can beat up whatever camera you just wasted your money on.

DCEPTCN

  • Guest
where the f&*k you been????
« Reply #42 on: May 30 2006, 05:43:34 PM »
Quote from: "87natty @ Tue May 30, 2006 2:15 pm"
Ray's car gave me the piss shivers when I saw it.
Sadly, I never got to see his TR, but he had a pretty sweet Tahoe!
Logged

Offline Recklessrob

  • Turbo Street Outlaw
  • *******
  • Posts: 5112
  • PSI: 3
    • View Profile
Re: where the f&*k you been????
« Reply #43 on: May 30 2006, 09:24:10 PM »
Quote from: "blown1 @ Mon May 29, 2006 7:52 pm"
I already have a hemco, 65mm I think,
Logged
Rob
Pages: 1 2 [3]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal