Knock, Knock, Whos There? Help!

[Scoobum]

Take a cigarette pack and cut a piece 3/8" wide and 3" long then loosen the sensors and slide the card board in long ways threw the slot, then push the sensor up tight to the card board and tighten the sensor back down then pull the card board out and you will have the 25 tho you need. It works every time.
 

I heard rumour of a GN up in Canada that's gone 6.7 with stock junk and a few bolt ons that uses that method.

[278CIKILLER]

Like Brand and I say keep it simple and you can't go wrong.

[motorhead]

I need to learn to read....smh

Did you check the clearances to see if you had 0.025-0.030 inches between that side of the blade and the slot in the damper?  Damn sure iooks like it is rubbing!  That may be the source of the ticking there.

When you watch it at idle...be watching it when the engine is cranked and see if the crank moves in or out to that it then touches.  Thinking about a worn thrust bearing

I checked it with a home Depot gift card and it's a little thinner in size but I figured its a good start. Well the cards can't even slide through, there isn't enough room. I tested it with all three fins.

Sent from my SM-N910T using Tapatalk

I set mine with a piece of a Coke can... which is slightly healthier than smoking.

[278CIKILLER]

You keep wasting your money on coke and your car. Your waste not mine.

[larrym]

I use a  plastic coke bottle

[Steve Wood]

I use a  plastic coke bottle

gives you a nice pre-curved feeler gauge!

[Just a Six?]

I use a  plastic coke bottle

gives you a nice pre-curved feeler gauge!

You gotta love a Curved Feeler Gauge!

[Steve Wood]

A banana works for bigger gaps!

Sent from my LG-H810 using Tapatalk

[deathraider6996]

Well guys, I took there adjusted the crank sensor with the aforementioned cigarette box method. I then went to start it up and it wont idle without shutting off. I can rev it a little bit to keep it from shutting down but of course the knocking sound it back. Still constant with RPM.

It is also smoking like crazy from the tail pipes. White smoke. lots of cloudy white smoke.

new plugs, oil, filter, radiator, radiator fluid,

[Steve Wood]

back to the blown head gasket, I think

[TexasT]

Have we put a compression gauge on it yet?

[deathraider6996]

Have we put a compression gauge on it yet?

Yes sir, all +/- 5 of 120

Sent from my SM-N910T using Tapatalk

[deathraider6996]

back to the blown head gasket, I think

Thats what I'm thinking.

Sent from my SM-N910T using Tapatalk

[larrym]

what did the plugs look like when they came out any really clean ones?

[Scoobum]

Call NASA and tell 'em to crank up the Hubble Space Telescope to search for your headgaskets orbiting the planet. That knocking sound you're hearing...that's consistent with RPM...mite be a rod bearing that's been pounded into tinfoil from KR.