700-4R filter

[Shimy87]

I've been reading that this is a better filter to use as it picks up from the bottom, not the top. If I'm understanding it, you can remove the 4th gear pressure switch, install a 90 degree brass adapter and reinstall the switch and then the 700 filter will fit and then just reinstall the pan? Is this the deal or is it just a waste of time and effort?

Thanks!!

[Forzfed]

Do you have a deep pan?  Better to have an extension tube that mounts as far back and as close to the bottom as possible.  I have a unit like this that I bought from PTS, I really like it.  Under hard acceleration there the filter is never starved of oil.

[gusszgs]

I  have a Hughes deep aluminum pan and the 700 filter fits perfect with it. I didn't change anything with the pressure switch, just heat shrinked over the connector so it wouldn't ground out to the filter body.

[Shimy87]

Wanted to keep stock pan.....is that possible

[larrym]

Need a spacer CK sells them.

[Forzfed]

You can also separate the two wires so they go on each side of your pickup, probably the cheapest solution.  I've done that and put some plastic ties around the wire, both work.

[TexasT]

I have a 700 filter under the stock pan. Ideal situation? No, but it fit my budget. See my build thread in the trans section for pix of the shrink wrap as James mentioned above. Working so far. I run it a quart over the full mark on the stick to prevent "sucking air".

[Steve Wood]

Just put a half quart of fluid above the fill line on the stick and worry about something that is more likely to affect you in your current combo

[Shimy87]

I have a 700 filter under the stock pan. Ideal situation? No, but it fit my budget. See my build thread in the trans section for pix of the shrink wrap as James mentioned above. Working so far. I run it a quart over the full mark on the stick to prevent "sucking air".

WOW, I couldn't take that on! I see what you did with the shrink tube, I think that's what I'm going to do also so I can use that filter. Where did you end up putting your temp sensor, pan or output line?

[TexasT]

We didn't get that far. I would probably tap it into the side of the pan or tee a cooler line ,either would give an idea.