« previous next »
Pages: [1]   Go Down

Author Topic: pressure drop on pte stock location intercooler  (Read 2112 times)

0 Members and 2 Guests are viewing this topic.

Offline dyermullet

  • Turbo Street Limited
  • ***
  • Posts: 159
  • PSI: 0
  • Boost n00b
    • View Profile
pressure drop on pte stock location intercooler
« on: September 21 2015, 05:42:27 PM »
Has anyone measured the pressure drop on the PTE SLI?  I did some searching but didn't find the answer.

I was reading Steve's combination article, at the time Bob Dick didn't test the PTE SLI.  It probably wasn't being produced at that time.
http://www.vortexbuicks-etc.com/combination.htm
Logged

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5599
  • PSI: 3
  • RED-RETIRED EXTREMELY DANGEROUS
    • View Profile
Re: pressure drop on pte stock location intercooler
« Reply #1 on: September 21 2015, 05:45:33 PM »
PACECARTA will have it. Check with him on the other board.
Logged
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal