« previous next »
Pages: [1]   Go Down

Author Topic: Cracked Alky Tank-Repair Suggestions  (Read 4811 times)

0 Members and 4 Guests are viewing this topic.

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5603
  • PSI: 3
  • RED-RETIRED EXTREMELY DANGEROUS
    • View Profile
Cracked Alky Tank-Repair Suggestions
« on: February 27 2012, 05:07:31 PM »
I drove the GN right up until the snow started a few weeks back. I noticed the tank was mysteriously empty the last time I drove it. I filled it up and parked it. Looks like winter's over so I went out and fired it up...and sure enuf...the alky tank is empty. I noticed it has a seam so it's actually two pieces glued together...and I'm betting the seam has cracked underneath it. What do you guys recommend for a repair? Hot glue gun? Epoxy?
Logged
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline SuperSix

  • Administrator
  • Turbo Street Outlaw
  • *******
  • Posts: 5072
  • PSI: 234
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #1 on: February 27 2012, 05:18:06 PM »
Silicone should work fine.

The radiator overflow tank for my Suzuki LTZ400 got a hole in it. I skinned around the area with a thin coat f silicone, then put a thin piece of plastic (Cut from a blister pack for something I had used) put it over the hole, then skinned over that with a bit more silicone.
Logged
'87 GN, 60lb, TA49, THDP, FTP cam, T+ lots o' shit - SOLD
'07 Ford F150 Lariat 2WD, 5.4L 3v - 255k
'20 Kubota BX2380. FEL, 60" deck
'78 IH/Case 184 Lo-Boy
'99 Kawasaki Bayou 400 4x4

Offline Top Speed

  • Don't Tread on Me
  • Turbo Street Outlaw
  • *******
  • Posts: 2548
  • PSI: -2
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #2 on: February 27 2012, 05:21:41 PM »
What will hold up to 100% methanol?  How much is a new tank, $30?
Logged
Champion Irons w/T&D roller rockers, TA-61 turbo, 206/206 Comp Cam,  57 lb/hr Siemens Injectors, 3000 stall PTC, PTE Plenum w/RJC Power Plate, 70 mm Accufab Throttle Body, RJC 325 Megacooler, TurboTweak 5.7/ Alky Control w/M1 methanol, 23 psig on the street, Puddn' Power engine, Borla Exhaust

Chris

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Cracked Alky Tank-Repair Suggestions
« Reply #3 on: February 27 2012, 05:48:02 PM »
Automotive Goop
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline Grumpy

  • Turbo Street Modified
  • *****
  • Posts: 498
  • PSI: 4
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #4 on: February 27 2012, 06:59:16 PM »
Julio's kit ??? If so call him an just get a new one  :chin:
Logged

Offline 1KWIKSIX

  • Turbo Street Modified
  • *****
  • Posts: 303
  • PSI: 0
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #5 on: February 27 2012, 07:19:55 PM »
Hey Brad,
 
That line on the tank is called the "knit line", that's were the mold (2 piece) separates when the tank is molded.
 
As others have suggested, I wouldn't take a chance phaulking around with trying to repair it......alcoho l has a pretty low flash point & is too volatile to take a chance with. Any leaks in your engine compartment and comes close to a red hot engine part or spark and you're toast!
 
I would simply replace it for the little cost that it is. Don't play with fire!
 
dave
Logged

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #6 on: February 27 2012, 07:36:12 PM »
Re-read the MSDS for Methanol.
Silicone- not so good:
http://www.helukabel.de/pdf/english/technik/X_065_Chemical_Resistance_of_Silicone.pdf

Buy a new tank.
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Cracked Alky Tank-Repair Suggestions
« Reply #7 on: February 27 2012, 07:37:53 PM »
automotive goop is made for such
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5603
  • PSI: 3
  • RED-RETIRED EXTREMELY DANGEROUS
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #8 on: February 27 2012, 07:38:25 PM »
Are the tanks still available from the dealer?
Logged
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon

Offline Charlief1

  • Just another kinky six
  • Turbo Street Eliminator
  • ******
  • Posts: 1348
  • PSI: 2
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #9 on: February 27 2012, 07:53:17 PM »
You can get a plastic welding kit from harbor freight if you want to repair it but unless you do more than this one thing it's cheaper to replace it.
Logged
And remember, when dealing with children, silence may be golden but duct tape is silver.

Offline gbsean

  • Turbo Street Modified
  • *****
  • Posts: 643
  • PSI: 1
    • View Profile
    • http://www.buickperfomancegroup.com
Re: Cracked Alky Tank-Repair Suggestions
« Reply #10 on: February 27 2012, 08:06:17 PM »
somebody was making re-pros...thought it was Glen...I bought 3 but sold them with car
Logged

Offline Scoobum

  • Turbo Street Outlaw
  • *******
  • Posts: 5603
  • PSI: 3
  • RED-RETIRED EXTREMELY DANGEROUS
    • View Profile
Re: Cracked Alky Tank-Repair Suggestions
« Reply #11 on: February 27 2012, 08:19:14 PM »
Quote from: gbsean on February 27 2012, 08:06:17 PM
somebody was making re-pros...thought it was Glen...I bought 3 but sold them with car

Checked Glens site...he ain't got 'em.
Logged
Hard work pays off, dreams come true. Bad times don't last, but BAD GUYS do!

RIP Scott Hall AKA Razor Ramon
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal