« previous next »
Pages: [1]   Go Down

Author Topic: Orange ECM wire  (Read 2129 times)

0 Members and 1 Guest are viewing this topic.

Offline Shimy87

  • Turbo Street Eliminator
  • ******
  • Posts: 1248
  • PSI: 2
    • View Profile
Orange ECM wire
« on: June 19 2014, 12:21:58 PM »
If I unplug this by the battery can i crank the car over but it wont start? I need to prime new turbo with oil before starting and thought this would work?
Logged
87 GN, K&N cold air, gutted cat, TT 5.7 chip, AFPR, 340 Walbro w/ hotwire, 60 LBS injectors, 981 valve springs, 206/206 Cam, RJC Powerplate, LS1 MAF & translator, Vacuum brakes, Hellwig rear sway bar, Energy suspension poly bushings, Razors Alky, Pypes exhaust, 5931 turbo, CK9.5 converter

Offline good2win22

  • Turbo Street Outlaw
  • *******
  • Posts: 2019
  • PSI: 0
  • No man lives happily lest he remove the boredom
    • View Profile
Re: Orange ECM wire
« Reply #1 on: June 19 2014, 01:01:25 PM »
Yes, it will not start if you unplug the orange wire
Logged
Jason

1966 Ford Ranch Wagon
1982 Jeep Wagoneer Limited
1986 Grand National BLK PHNX
1987 Turbo Regal Limited
2018 Ram 2500 Cummins

Offline SuperSix

  • Administrator
  • Turbo Street Outlaw
  • *******
  • Posts: 5072
  • PSI: 234
    • View Profile
Re: Orange ECM wire
« Reply #2 on: June 19 2014, 02:46:10 PM »
Excellent way to disable the engine - poor man's antitheft too.
Logged
'87 GN, 60lb, TA49, THDP, FTP cam, T+ lots o' shit - SOLD
'07 Ford F150 Lariat 2WD, 5.4L 3v - 255k
'20 Kubota BX2380. FEL, 60" deck
'78 IH/Case 184 Lo-Boy
'99 Kawasaki Bayou 400 4x4

Offline motorhead

  • Turbo Street Outlaw
  • *******
  • Posts: 2267
  • PSI: 4
  • look at my balls... look at them!!!
    • View Profile
Re: Orange ECM wire
« Reply #3 on: June 19 2014, 08:55:16 PM »
Or just disconnect the injector harness and save any settings/memory in your ECM/chip.
Logged
>>>Das Instagram<<<
'80 LeMans Wagon|'87 Monte Carlo SS|'92 Camaro Z28|'07 TrailBlazer SS|'15 Colorado Z71|'19 Hellcat Widebooty M6

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Orange ECM wire
« Reply #4 on: June 19 2014, 09:08:54 PM »
Just install the turbo and crank it up...in two seconds it will be supplied with oil.  Being as there is no load on the turbo, and hence, no boost, there is no need to crank the engine over to supply oil to it.  The turbo only works when it is making boost...there is nothing to break in as Paul stated.
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal