« previous next »
Pages: [1]   Go Down

Author Topic: No 1st gear shift?  (Read 2487 times)

0 Members and 1 Guest are viewing this topic.

Offline YGspider

  • The Turbo Geek
  • Turbo Street Limited
  • ***
  • Posts: 133
  • PSI: 0
  • 87 Turbo T
    • View Profile
No 1st gear shift?
« on: September 27 2013, 10:11:08 PM »
So I'm wondering if a TV cable adjustment is in order on my car because I cant pull the shift lever into first gear. Also can the TV adjustment limit or determine how much RPM you will get?
Logged
Stratman: Is it even running?

Offline earlbrown

  • Turbo Street Eliminator
  • ******
  • Posts: 1571
  • PSI: 6
    • View Profile
Re: No 1st gear shift?
« Reply #1 on: September 27 2013, 10:41:52 PM »
Pulling it into first gear requires that the bracket on the trans pan not be tweaked in the least. That's with the shifter cable adjusted dead nuts accurate.

On the TV cable it's not supposed to alter shift points but if you over tighten it, it does seem to affect shifting along with the quality.
Logged
'87 GN - 4.2L SFI Turbocharged innercooled V6 - Chrome valve covers - supra pump - 14" K&N - 52mm throttlebody - rocker shaft supports -  1/2 intake spacer - TB coolant bypass - 3" ATR exhaust tip - Alum intake pipe - NOS timing cover - chip - relocated charcoal canister - CR42's - stock

Offline YGspider

  • The Turbo Geek
  • Turbo Street Limited
  • ***
  • Posts: 133
  • PSI: 0
  • 87 Turbo T
    • View Profile
Re: No 1st gear shift?
« Reply #2 on: September 27 2013, 10:47:53 PM »
So if your trans is setup for a more aggressive shift you cant pull first gear? Thanks for the info man.
Logged
Stratman: Is it even running?

Offline earlbrown

  • Turbo Street Eliminator
  • ******
  • Posts: 1571
  • PSI: 6
    • View Profile
Re: No 1st gear shift?
« Reply #3 on: September 28 2013, 01:24:02 AM »
no, if the bracket is bent the least little bit it won't go down to first.
Logged
'87 GN - 4.2L SFI Turbocharged innercooled V6 - Chrome valve covers - supra pump - 14" K&N - 52mm throttlebody - rocker shaft supports -  1/2 intake spacer - TB coolant bypass - 3" ATR exhaust tip - Alum intake pipe - NOS timing cover - chip - relocated charcoal canister - CR42's - stock

Offline YGspider

  • The Turbo Geek
  • Turbo Street Limited
  • ***
  • Posts: 133
  • PSI: 0
  • 87 Turbo T
    • View Profile
Re: No 1st gear shift?
« Reply #4 on: September 28 2013, 07:21:25 PM »
Quote from: earlbrown on September 28 2013, 01:24:02 AM
no, if the bracket is bent the least little bit it won't go down to first.

Oh okay I understand.
 
Logged
Stratman: Is it even running?
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal