Did I fry my ECM

[ULYCYC]

Knowing that I would really check out all the harness wiring. Look for water damage and also around the ecm area

[larrym]

I had the same issue lost the power wire it was a pita to get back in and solder in place so it would not pull out again chances are it is not pugging into the ECM properly. did the wire pull out of the connector or the connector out of the harness?
 

[gbsean]

check to make sure non of the grounds pulled out

[Ficco87gn]

After not working on my car for a few weeks due to going back to work after a 4 month layoff(Union Ironworker), I found my problem. Bad connection on the power wire. Thanks for all the good advice guys

[Steve Wood]

glad you found it, and glad you got back to work.  If you can find anyone to vote for that will actually encourage manufacturing in this country other than flipping burgers, vote for them/him/her

[gbsean]

funny how many times an issue is solved by checking the ECM power wire....been there done that...

[Steve Wood]

Now if we can teach you that it is the ecm memory wire, we will be in tall cotton! 

[Ficco87gn]

Glad I actually decided to go to the garage after work and try to figure it out. Now I just need to adjust my new TPS and IAC and hopefully it will fire up and break in the cam.


Steve, I hear you. As my favorite sticker on my hard hat says " Put Americans To Work Buy American
Made

[Steve Wood]

damn good sticker....

[gbsean]

Now if we can teach you that it is the ecm memory wire, we will be in tall cotton! 

you knew what i meant...lol

[Steve Wood]

yeah, but it is more fun to jab  you!

[SuperSix]

Silly Brit

[Steve Wood]

Silly Brit

Over there, they would say Silly Twit