« previous next »
Pages: 1 [2]   Go Down

Author Topic: Powermaster short cycling  (Read 9836 times)

0 Members and 3 Guests are viewing this topic.

Offline Turbodave

  • Bone Stock
  • **
  • Posts: 89
  • PSI: 0
    • View Profile
Re: Powermaster short cycling
« Reply #15 on: August 10 2011, 06:45:17 AM »
There is one other possibility.  Not as likely, but still a contender, and that's the pressure switch going bad.  The one on my 87 went bad a few months ago and it acted quite similar to yours.
Logged
TurboDave EWCS(SW) USN (Ret.)
Sevierville, TN
Translator Pro;  MAFless fuel, spark, boost and fuel pump management

86 GN(Translator Pro/Extender Pro/w Boost control, PLX WBO2 (original owner)

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Powermaster short cycling
« Reply #16 on: August 10 2011, 08:29:47 AM »
I guess I have to swap and try another one, I just struggle with grok-ing  a switch failure mode
that causes THAT phenomena. Self heating? (a stretch ) Dunno.
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline ULYCYC

  • Turbo Street Modified
  • *****
  • Posts: 872
  • PSI: 4
    • View Profile
Re: Powermaster short cycling
« Reply #17 on: August 10 2011, 09:10:12 AM »
As TurboDave said check the pressure switch. Seen many cause short cycle..
Logged
ED BAKER
87-T, Maplight equipped rear view mirror..
01 Park Ave Ultra S\'charged
BPG#1458

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Powermaster short cycling
« Reply #18 on: August 22 2011, 10:26:35 PM »
I had a painful email discussion with Rockauto last week.
Even though they will happily bill me in Canadian Dollars they will not allow me to send a PM
to one of the two Canadian Cardone depots (one a block from work) for a R&R - but I would have to send it to Philly for rebuilding.  :x
 
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Powermaster short cycling
« Reply #19 on: August 22 2011, 10:47:54 PM »
But Yes- I'll try a switch first.
Do you think anyone had a 1 1/2 socket in stock, nah.
After my Crescent wrench slipped and f'd my spare reservoir I realized:
A water heater element wrench is 1 1/2. and cheap.
And the guy with the switches was too busy with his Turbo garden party planning
to ship it.
 

Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Powermaster short cycling
« Reply #20 on: September 25 2011, 11:25:10 PM »
The switch made no difference, the cycle rate stays the same.
I did score a PM rebuild kit, I don't know anywhere local I'd entrust with this valuable commodity.
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto

Offline daveismissing

  • Two Buicks- too little money$$
  • Turbo Street Outlaw
  • *******
  • Posts: 6517
  • PSI: 3
  • Two Buicks- too little money$$
    • View Profile
Re: Powermaster short cycling
« Reply #21 on: October 19 2011, 08:31:33 AM »
The prattling purveyor of Powermasters from Pennsylvania has pronounced a paucity presently.
pensive
Logged
-Drain plug by Earl Brown, custom oil pan by Rich's Auto
Pages: 1 [2]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal