« previous next »
Pages: 1 [2]   Go Down

Author Topic: New Earl Brown Product  (Read 8291 times)

0 Members and 2 Guests are viewing this topic.

Offline larrym

  • Turbo Street Eliminator
  • ******
  • Posts: 1363
  • PSI: 1
    • View Profile
Re: New Earl Brown Product
« Reply #15 on: June 25 2015, 01:43:35 PM »
Quote from: earlbrown on June 25 2015, 11:00:26 AM
I've never been asked for a refund  :D



On the magic seal valve covers, keep in mind, you're sealing against a rough cast convex head.    Then again I can't figure out how to make it better.  I used the same Fel-Pro cork gaskets from '98 all the way up until now.  The only thing that leaked was my PS breather.  Kinda hard to top that.





Same type or same set?
Logged
86 white T type with t tops and blackout trim. 60lb injectors Gen 2 with Extender Chip TR6 ignition 212/206 roller cam Turbonetics BB CPT 61 CAS V4 Intercooler Cobbled together Alky Injection 4 inch MAF pipe with integral sensor
2800 stall lots of fun with a little 6 banger!
Best ET 11.36

Offline earlbrown

  • Turbo Street Eliminator
  • ******
  • Posts: 1571
  • PSI: 6
    • View Profile
Re: New Earl Brown Product
« Reply #16 on: June 25 2015, 02:25:44 PM »
Same exact gaskets.
Logged
'87 GN - 4.2L SFI Turbocharged innercooled V6 - Chrome valve covers - supra pump - 14" K&N - 52mm throttlebody - rocker shaft supports -  1/2 intake spacer - TB coolant bypass - 3" ATR exhaust tip - Alum intake pipe - NOS timing cover - chip - relocated charcoal canister - CR42's - stock

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9950
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: New Earl Brown Product
« Reply #17 on: June 25 2015, 02:37:39 PM »
that would suck...I mean that leaks
Logged
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.
Pages: 1 [2]   Go Up
« previous next »
 
SimplePortal 2.3.7 © 2008-2024, SimplePortal