Author Topic: Alky on the way!  (Read 5599 times)

0 Members and 2 Guests are viewing this topic.

Offline Shimy87

  • Turbo Street Eliminator
  • ******
  • Posts: 1245
  • PSI: 2
    • View Profile
Re: Alky on the way!
« Reply #15 on: June 14 2013, 12:09:08 PM »
Well I might actually get time to put this in next week!! I have not sent my TT chip in to be re-burned for alky. From what I've seen i think i can install the system using this chip, just make adjustments to it? Would anyone have advise as to where to set the timing and fuel for starters when i start to turn up the boost?  I only have a SM for tuning.
 
Thanks!!!
87 GN, K&N cold air, gutted cat, TT 5.7 chip, AFPR, 340 Walbro w/ hotwire, 60 LBS injectors, 981 valve springs, 206/206 Cam, RJC Powerplate, LS1 MAF & translator, Vacuum brakes, Hellwig rear sway bar, Energy suspension poly bushings, Razors Alky, Pypes exhaust, 5931 turbo, CK9.5 converter

Offline Steve Wood

  • Turbo Street Outlaw
  • *******
  • Posts: 9940
  • PSI: 34
    • View Profile
    • http://www.vortexbuicks-etc.com/
Re: Alky on the way!
« Reply #16 on: June 14 2013, 02:59:33 PM »
it will be a little rich at mid range,, but it will work.

Eric normally sets the timing to 23 in first and second and 21 in third and fourth as I recall
Steve Wood

http://www.vortexbuicks-etc.com

A lot of broken parts does not make you a racer; it makes you a slow learner.

 

SimplePortal 2.3.7 © 2008-2024, SimplePortal