AN Hoses/fittings

[SuperSix]

Started building my first AN hoses. I am making some -6AN trans cooler lines.

Any tips to cutting the hoses FLUSH?
Using an air cut off wheel, I tried duct tape - it sucked, tightly wound electrical tape, sucked a bit less, and then a small hose clamp, which worked pretty good.

[ULYCYC]

I use the anvil butt of a bench vise and a large mechanic's cold chisel.  A good hard blow with 5lb hammer cuts it clean.

[SuperSix]

I use the anvil butt of a bench vise and a large mechanic's cold chisel.  A good hard blow with 5lb hammer cuts it clean.

I will have to try that.

Thanks

[ULYCYC]

Make sure the chisel is sharp and don't miss. It takes about two weeks for the thumb to feel better

[SuperSix]