Need your help pls - what size wrench to remove brass turbo drain bushing

[1KWIKSIX]

Am going to remove my stock turbo drain line from the block tomorrow. Unfortunately , car is stored about an hour away, so I can't determine the proper sized wrenches to take.
 
Can anyone tell me what size wrenches I need to remove both the large brass hex bushing & the nut on the end of the turbo oil drain line?  This area is difficult to reach using an adjustable wrench as it's pretty crowded.
 
Thanks for your help.
 
 
dave
 
 
 
 

[SuperSix]

I had to use adjustables.. Pain in  the ass.

[1KWIKSIX]

yeah, guess I should'a changed it over before I put on my new TA front cover! 
     DAH.....
 
If anyone can tell me what size wrenches go on these two hex nuts, I'd be extrememly appreciative.
 
thx
 
dave

[Pyro6]

Mine has 1 1/4" on the block side and 1 1/16 on the flex tube

[1KWIKSIX]

Mine has 1 1/4" on the block side and 1 1/16 on the flex tube

Thanks very much!
 
dave

[motorhead]

Hammer?

[1KWIKSIX]

turbo drain came out easily with the 1 1/16" wrench.....I used a large socket and johnson bar to remove the brass bushing...came out easy!  Much easier than using a wrench on it. I didn't have to remove the water temperature sending unit or the thermostat housing either......